5 replies to this topic

[Yazz]

Open yer gun. First, you wanna get the six barrel part out. Along with that, here are a lot of pieces that can go. You only need the basics. Just hot glue a 1/2" male PVC threaded adapter(the threaded part)over the hole. After that, just glue 5 or 6" of 9/16 brass into the adapter and let fly. it gets about 50+ feet(30 accuret), and basically shoots where you aim the barrel. Its worth a shot.

Edited by Yazz, 12 May 2005 - 03:19 PM.

[duce]

I don't have an at3k but 50 feet seems rather short for what I've heard. Other than that, nice mod.

[Yazz]

Yea, its not great. But when it comes down to u and him, its pretty handy! Besides, it took me less than 2 minutes to do.

Edited by Yazz, 12 May 2005 - 03:33 PM.

[AirApache]

See I don't get why you'd waste your at3k on a single barreled mod, especially since it only gets 50 feet.

The at3k when modded correctly can have 6 shots with each having an average of 70-80 feet. You must have been out of your mind to 1) single an at3k 2) only get 50 feet out of a SINGLED mod!

[Team Slaya]

Derek, it went a lot further than 50', and i doubt you range tested it outside.

Oh, and Apache - we didn't have any PETG or other materials to six barrel it, plus the gun was pretty fucked up when we got it, so i'm happy with the results he's getting.

TS

[Uncle Hammer]

Ah some people. So, you don't need any damn petg. CPVC or Brass can do the trick. They get very simialr results, petg is just lighter and cooler .

Edited by Uncle Hammer, 13 May 2005 - 04:32 PM.