No replies to this topic

[Jay Dub]

Hello fellow Nerfers,

I was just looking through my arsenal and found an old razorbeast. I ripped it open and started brooding ideas. So far this is roughly what I thought I could do. Take all guts out and discard. ( This is the reason I thought it would be suitable to put this topic in the homemade section. ) I plan on creating a spring gun, for the simple reason that a pump would be similar to my other guns and the awkward position the pump would be in. Most likely the spring would be bolt-action, but not a copy of Bolt-losers beautifully put together rifle. I plan on keeping most of the razorbeast shell but put the trigger off to the side of it. (It just fits my hand positioning when I play.) Some questions remain though:

1) Should I use a breech load or 3dbbq's barrel for this gun?
2) Does 3dbbq's barrel work decent with a spring gun?
3) Could it be possible to make interchangeable barrels between a breech and 3dbbq's?
4) Is there a way that a shell-less clip could be made to fit into the razorbeast, preferably onto the breech? (I'm still looking around and working on shell-less clip ideas.)

Again here is the briefing: trigger on side, bolt action, and keeping most of the outside.

Ideas and answers would be appreciated. Thank you.

-J_Dub-