Jump to content


Photo

A Bit Of Mav Help


5 replies to this topic

#1 duce

duce

    Member

  • Members
  • 342 posts
  • Location:Ann Arbor MI (southeast MI)

Posted 12 March 2005 - 04:41 PM

Hey, I just picked up a Maverick and am starting to mod it. I have opened up the gun and taken the cylinder out. I can't seem to get the cylinder apart though. I have taken all the screws out of it but I still cant pull it apart. Any help at all?
  • 0
"Thats so good it makes me want to kick my mom in the face." -Halfling

#2 parmaster320

parmaster320

    Member

  • Members
  • 90 posts
  • Location:Wisconsin

Posted 12 March 2005 - 04:46 PM

First you have to take the six screws out of it (3 on each end). Now what's holding it together is a metal rod in the middle. I found an effective way was to put the barrel system vertically with the dart end of the barrels facing down. I put the barrels down on 2 blocks of wood that are just a ways apart, put the middle of the cylinder over the space between your blocks. Then take something skinny like a screwdriver and put it right on the metal rod, you can see it from the top it's inside the little orange piece in the middle. Then just pound it in a little bit and it will make it much easier to pull apart. Be careful, those springs may go flying. Hope this helps if not say so.
  • 0

#3 duce

duce

    Member

  • Members
  • 342 posts
  • Location:Ann Arbor MI (southeast MI)

Posted 12 March 2005 - 04:51 PM

Thanks for the quick reply, Im going to go try it right now.
  • 0
"Thats so good it makes me want to kick my mom in the face." -Halfling

#4 moosenukem

moosenukem

    Member

  • Members
  • 405 posts

Posted 12 March 2005 - 11:53 PM

You have to pull VERY VERY hard, just make sure you hjave something to catch the springs when they come poppin out. And do it in a small room so if it does blow everything everywhere it's easyier to find.

Good luck...You'll need it... ^_^
  • 0

#5 danerfpimp

danerfpimp

    Member

  • Members
  • 7 posts

Posted 05 May 2005 - 09:13 AM

Thanks.

I couldn't get it apart either. This should help.
  • 0
THE One and Only, Nerf Pimp

#6 NinjZ

NinjZ

    Member

  • Members
  • 1,005 posts
  • Location:jersey

Posted 05 May 2005 - 09:46 AM

If you move the parts a bit, you can get a thinner pair of pliars inbetween the plastic bits. Grip the metal bar with the pliars and put it on the floor. Stand on the pliars and pull up on the revolver. It should come apart. Thats what I did anyways. That sucker is held together REALLY tightly.
  • 0


0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users