Does anybody know of an easy/effective way to get at the over pressure release valve on guns like the LBB or the Big Salvo, which have an orange cap glued over the pump housing?
Over Pressure Valve On Lbb
Started by parmaster320, Feb 20 2005 02:15 AM
5 replies to this topic
#2
ompa
-
- Moderators
- 2,368 posts
Introductinator
Posted 20 February 2005 - 10:07 AM
You COULD cut through it, or, since it seems those paticular guns already have enough power, you could just leave it. But if you are intent on getting at the overpressure release valve, you should just cut through the tube itself, preferably near the cap, and just epoxy it back together when you're done.
~ompa
~ompa
#3
parmaster320
-
- Members
- 90 posts
Member
Posted 20 February 2005 - 12:35 PM
Will mounds of hot glue work? Because I'm not sure if I have epoxy right now.
#4
stanpig
-
- Members
- 72 posts
Member
Posted 20 February 2005 - 03:42 PM
all right thanks!
P.S. how do I get an avatar?
P.S. how do I get an avatar?
#6
Tinkerer
-
- Members
- 204 posts
Member
Posted 21 February 2005 - 05:54 PM
anyway, you can use a pair of pipe wrenches, and that'll usually take the orange cap off cleanly, then just put it back on with some superglue
Actuall directions on some products:
On Pudding
"Product will be hot after heating"
On a Sweedish Chainsaw
"Do not try to stop with hands or genitals"
(Was alot of this happening somewhere? MY GOD!!)
On Pudding
"Product will be hot after heating"
On a Sweedish Chainsaw
"Do not try to stop with hands or genitals"
(Was alot of this happening somewhere? MY GOD!!)
2 user(s) are reading this topic
0 members, 2 guests, 0 anonymous users
