There isn’t too much to say about this one. It’s exactly what the title says. Cage main and wheels to support the T-Motor F80 Pro. I’m using the 1900KV version.
Because of how close the wire on the motors got to the flywheels, I changed the wire channels in the cage main from just a ditch to a ditch with a cover over it. Makes it a little tricky to snake the wires through, but not too bad.
I used the mag release with the circular surface, which seems to work fine with Rapidmag heavys. Both mags I printed had to be corrected, one with a file, one with a design change prior to printing. The protrusions on the back made them a very tight fit in the magwell. I also remixed the design on the second the one pictured to have press-fit and then bolted in connectors between the top and bottom halves of the extended version, rather than using a glued on connector band. I used some dovetail shapes to keep the magazine walls aligned, although I didn’t think of this until after printing the left half of the mag so they’re only tested on the right. I also have a modified two-part pulley that is way easier to install. I have not tested this magazine in actual combat yet, so be warned if you want to use it.
Obviously most of the design credit goes to torukmakto4. A little to Matthew Bregg for the motor key geometry from the Orb Weaver, but I changed the wheel socket diameter because at least with my motors, the dimensions provided led to an extemely loose fit and defeated the purpose of rotor-centric flywheels.
Filaments are Yoyi transparent violet and eSun orange and white.
Files are located in: https://drive.google...2_5?usp=sharing
I’ll also use this time to talk about a few other mods I made to the T19 parts that aren’t specific to this MEGA version. The bottom of the vanilla trigger guard has a sharp corner that dug into my finger so I made a smoother version. I added a hole for a second screw between the stock base and the PVC pipe since the stock wobbles very slightly on my other T19. I knurled the velocity knob since the plain one was very slippery. Those files are in: https://drive.google...2EE?usp=sharing
