I opened up my airtech 4000 to try to block the airpump, but it came at a price.... I had some screw problems so i pretty much had to pry the gun open. The insides got jumbled up before i could see how they started. I was wondering if anyone can give me a basic photo of the inside of they're 4000.
-WarGhost
3 replies to this topic
#2
Dan Wask
-
- Members
- 436 posts
Member
Posted 28 August 2004 - 01:20 AM
Its basically the same for the 4k, what I usually do is figure out where the stuff fits into the slots, it usually works well doing that. Although most of the confusing stuff is screwed down, so I'm not sure what could be that difficult.
Stolen/borrowed/cnp'ed from the mods section
Edited by Dan Wask, 28 August 2004 - 01:21 AM.
| QUOTE (Arcanis @ Apr 9 2005, 12:02 AM) |
| When I insert a dick, nothing happens. |
#3
Renegade
-
- Members
- 536 posts
Member
Posted 28 August 2004 - 09:37 AM
Warghost, there's already a topic discussing the insides of the Air Tech4000.
http://nerfhaven.com...?showtopic=2715
http://nerfhaven.com...?showtopic=2715
#4
WarGhost
-
- Members
- 21 posts
Member
Posted 02 September 2004 - 11:19 PM
i got the airtech 4000 back together fine, but it barely shot. i opened it up about a week later and found that the hot glue was blown off the over pressure release valve, but i found no damage to the air tank. i put more hot glue on the over pressure release valve, but it's not much better. Any ideas?
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users
