1 reply to this topic

[YEETthatdart]

I made a brass barreled reactor that can be single shot or multi shot depending on how many darts you put in it. It requires you to cut out the white AR piece in the blaster, and then I suggest if you have any 1/2 cpvc (about 2 inches of it) to get that and a cpvc coupler and attach that to the back end of your brass and glue it in place. after that hammer the cpvc down the front of the gun (I suggest removing the spring pusher for balls instead of cutting it apart)and then place the cpvc part into the hole where the AR was. Then to center the barrel and hold it in place you should cut a hole into a reactor ball and wedge it on to the end of the brass side. The general range depends on the type of dart, accufakes work best IMO. The duct tape on the back of the gun is cause it has a broken screw port.

Attached Thumbnails

• 
• 
• 
• 
• 

[YEETthatdart]

I forgot : the reason you should put the coupler on the back is to make sure some darts don't slide all the way back into the air chamber. (it destroys the darts when you try to fire the gun,

Edited by YEETthatdart, 26 May 2019 - 04:50 AM.