First time Stryfe modder here. After careful consideration, research, and gathering of materials, I was ready to start my first Stryfe mod. My plan is to do a full rewire to run off of a 2S lipo, with Fang Revamped motors and stock wheels and cage, as the lipo charger kind of took up the price portion that would otherwise have been for replacement wheels and cage. I began gutting the blaster, clearing out the battery compartment, removing the flywheels and removing the motors, etc. However, when I got to the stage of putting the new motors in, I discovered two things:
1. The stock cage has no screwholes and uses no screws. Therefore I cannt screw the Fang ReVamped's in.
2. The Fangs are slightly wider than stock motors, so I cannot simply push them in for replacement.
I found this (https://www.youtube....h?v=clE3NPeXjhg from 2:28) helpful video, which said I have to dremel or sand out the motor slots in order for the new motors to fit. However, before I do irreversible things to my cage, I am looking for opinions. How have other people dealt with this before? Is dremeling or sanding the only way to go? Should I glue the Fangs in?
Thanks in advance.