Posted 25 August 2004 - 06:36 PM
Posted 25 August 2004 - 06:46 PM
First I got rid of the fluff. The yellow dot in the picture is a piece of plastic I super glued in the trigger groove to keep the trigger from sliding back and disengaging the mechanism. After this small modification (and a similar change to the other half of the case) I was able to remove and discard the blue piece and spring seen above. *** If you do this, make sure your cocking lever is ALL THE WAY forward before firing or you might be brutally maimed by the lever smashing down on you as your gun disintegrates. ***
~Cx's Mshot mod writeup.
I did that, well, similar to that, but accomplishing the same thing. Either way, do this, I think it helps, also, reinforce the back of your mshot, if not the whole thing. Anyways, cocking upside down is in no way bad for the gun, it doesnt build up stress or anything. You get used to it, its really no big deal, but I can see why you would be pissed.
And listen to Ompy
Edited by THIRST, 25 August 2004 - 06:46 PM.
Posted 25 August 2004 - 07:16 PM
Posted 25 August 2004 - 07:24 PM
Remember, reinforce your mshot! Don't want an assplosion, or worse, it to suffer the fate that Rag's did...
Edited by crankymonky, 25 August 2004 - 07:28 PM.
Posted 25 August 2004 - 09:23 PM
(this might be confuesing because it is hard to explain)
Posted 25 August 2004 - 11:00 PM
the plastic nub that holds the blue piece that straightens the plunger broke, so I replaced it with a screw that had the same diameter as the hole in the blue piece.I cocked the gun, and bam, a hugeass crack formed in the side where I put the screw.Then the cocking handle bottom broke.And the back of the gun.Saftey, plunger tube, plunger holders, plunger shaft...
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users