so i am do a nitemaverick intergration due to my maverick slide breaking but i don't know how to do one so can i get help

nitemaverick help
#1
Posted 30 May 2018 - 02:33 PM
#2
Posted 30 May 2018 - 09:02 PM
Looks like one was started back in 2008 - not sure how it ended up, but could be a good start-point.
tbh, I would look into attaching the pull-rod directly to the Mav's plunger head, rather than trying to integrate the NF internals, or find some way to attach it to the little metal rod in the slide - maybe with a horse-shoe shaped piece where the slide used to attach.
#3
Posted 30 May 2018 - 11:15 PM
i want to do a nitefinder integration with out any cutting
so is there a way to so that?
#4
Posted 31 May 2018 - 04:44 PM
Without shell cutting? Doubtful. Would have to take a lot of internal ribbing out of the shell and construct a new catching system in the shell.
"sexual innuendo no intendo"
#5
Posted 31 May 2018 - 08:12 PM
Integration without tools is completely impossible. On the whole, there are very few Nerf blasters with interchangeable internal parts. Without the knowledge or the tools for integration, you are going to need to think about this problem differently.
Forget the Nitefinder - try to find a way to repair or replace the broken slide on your Mav. If you can do that, then maybe you might be ready to try something as complex as an integration.
Start saving for some basic tools too. A fret-saw or hacksaw will be very useful, metalwork files - especially small hobby ones, and of course, epoxy glue for putting bits back together again afterward.
#6
Posted 31 May 2018 - 09:51 PM
i want to avoid unnecessary cutting so like a hole for the priming handle is necessary so i will be doing that
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users