2 replies to this topic

[ENP10]

Is there any way to open the Alphahawk after attaching the priming bar?

[Maniacal Coyote]

Pry it off with flat-head screwdrivers, like the Longshot bolt.

[Blasterthinktank]

Best way in my opinion is to jam something hard and thin into the gap right above the priming handle. I used the flathead screwdriver on my leatherman tool. The tool will be pressing up the small tab that locks the handle, so you need to be wiggling the handle out while pressing the tool in. Be careful not to end up jabbing yourself in the hand like I did. With a little patience and some brute force the handles will come out. Once they're out, you can shave a little bit of the plastic off the handle and it will be removeable in the future much easier.