Jump to content


Photo

At4000


5 replies to this topic

#1 bottlecap345

bottlecap345

    Member

  • Members
  • 13 posts

Posted 11 August 2004 - 05:04 PM

I just took apart and modified the Air tech 4000 and I can't figure out how one part of it goes back together. Please place a picture or give a link of the internal pieces. Please help!
  • 0

#2 okto

okto

    Member

  • Members
  • 590 posts

Posted 11 August 2004 - 06:48 PM

first mistake (i'm guessing): did you just open the case, or did you take all the guts out?
  • 0

#3 bottlecap345

bottlecap345

    Member

  • Members
  • 13 posts

Posted 11 August 2004 - 07:35 PM

I took mostly everything out and I just want a photo to see how everthing fits
  • 0

#4 reversedracula

reversedracula

    Member

  • Members
  • 170 posts

Posted 11 August 2004 - 09:24 PM

If you can describe the piece, I may be able to help you from memory... chances are it's that little black or gray thing on the back that's above the rod and near the trigger... or it's the black thing that has to do with the rotator. Describe your problem with greater clarity or post a picture and circle what's wrong in paint or something and I'll help you out.
  • 0
NERF OR NOTHIGN!11!eleven!!!one!!!one!11!!!!onhoundredandeleven!!!!!

#5 bottlecap345

bottlecap345

    Member

  • Members
  • 13 posts

Posted 12 August 2004 - 12:08 PM

I put everything together right except for the stuff that deals with rotating. Whenever I pump it, it just keeps rotating. I don't know what I did wrong.
  • 0

#6 reversedracula

reversedracula

    Member

  • Members
  • 170 posts

Posted 12 August 2004 - 02:47 PM

The rotator can go back in at many angles/notches. You have to make sure you get it on the right notch/thread that metal part and screw the gray cap on tight. If you continue to use it with it's constant rotation that's put together incorrectly, it'll likely break the plastic collumn that the rotator rests on. It's a difficult repair, but I can talk you through it... The trickiest part of putting the black part of rotator back on this that the little shark fin thing has to go down into a little notch. It's difficult to notice, but you have to push it down past the surface of the black outer part it sits inside. The part that turns the rotator is what has to be at correct angle. It is gray if I remember correctly. It's shaped like an egg and has to be pointed with the oblong part of the egg pointing up, I THINK. Make sure you get the screw on tight. It's a finnicky rotator but even if you destroy it, keep all the parts and I can talk you through repair. Good luck.
  • 0
NERF OR NOTHIGN!11!eleven!!!one!!!one!11!!!!onhoundredandeleven!!!!!


0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users