4 replies to this topic

[0MG1tz4l3x]

Hi, i have a nerf rapid strike with 2 of these http://www.ebay.com/...boAAOSwk1JWdcVm

im going to get a new lipo because i have 3 trustfires and the voltage sag is terrible. Could i possibly run these on a 4s? I'm also going to put a third one in for the pusher arm.

Thanks!

[JohnB]

Hmm...I've seen those before somewhere... I think it was FDS's guide to motors. 4S might be too much. To be honest those are actually relatively high-end motors, and really it's just overkill. I'm going to say 7.2 volts should be okay. But ask someone else.

 

Edit: If you don't have a voltmeter, get one. LiPo safety.

Edited by JohnB, 06 July 2016 - 02:04 PM.

[DjOnslaught]

Do yourself a favor, don't go above a 3s lipo and definitely make sure you use a voltage meter. Those are solid motors, but bear in mind they require cutting the shell in order to fit

[0MG1tz4l3x]

I have a voltage meter and i'm getting a 3s lipo soon, i just wanted to see if it was possible. I have another one of those motors that a snapped the magnet it a clamp and its missing a brush, i could test it on that one.

[0MG1tz4l3x]

I also already have them in a rapidstrike and im getting a third for the pusher arm, 3 trustfires isn't working that well right now.