I just finished Ragornocks mod for the Tech Target(the one on this website).
I went out to test the gun and when i fired it the dart only went up to the end of the 4 inch 9/16" brass barrel.I put my hand in front of the plunger and it feels like the gun isn't putting out very much air.Did I do something wrong with the mod or leave out a piece??
Problem With My Tech Target
Started by LiKnSmAkScOmIn, Aug 09 2004 02:43 PM
2 replies to this topic
#1
Posted 09 August 2004 - 02:43 PM
Morons With Guns own you.
#2
Posted 09 August 2004 - 03:50 PM
Open up the gun.
Make sure you actually have a seal...
Your lunger cap may have peartially broken off. If it has, Rags has a mod for it...somewhere. If your a fan of cpvc, just entirely rip off the plungr cap, and glue a cpvc coupler into there. You should get similar/just as good ranges as before, and now its a cpvc breech, or dont breech it. Whatever.
Oh yeah, and I hope your darts arent too tight in brass. Because it may just be a simple as that.
THIRST
Make sure you actually have a seal...
Your lunger cap may have peartially broken off. If it has, Rags has a mod for it...somewhere. If your a fan of cpvc, just entirely rip off the plungr cap, and glue a cpvc coupler into there. You should get similar/just as good ranges as before, and now its a cpvc breech, or dont breech it. Whatever.
Oh yeah, and I hope your darts arent too tight in brass. Because it may just be a simple as that.
THIRST
ko
#3
Posted 09 August 2004 - 09:22 PM
T'was the plunger cap.Thank's for your help.
The repair is on NerfHQ.
The repair is on NerfHQ.
Morons With Guns own you.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users