So I had a Clear Shot, and it was terrible (read: Crap Shot). Anyway, I had a spare NF spring, a screwdriver. and a bit of teflon tape. Now it's much better.
- Cup to hold your screws
- Nite Finder spring or the equivalent
- Teflon tape
- Philips Head Screwdriver
- Stormfire/Clear Shot
The Subject Before Surgery:
Lay the blaster on the table and start unscrewing the screws. (Note:They are of varying size, so be careful.)
There's a screw here:
and some hidden ones in the priming slide:
Once you have them all out, remove the one half of the shell.
Remove the plunger rod assembly (the gray part with the spring on it):
Now, unscrew the plunger head from the plunger rod and take it apart. It should look like this:
Ignore that for a second.
Take your new spring out. Then, pull off the old spring and put the new one on in its place.
Go back to your plunger head. Take the bottom piece and wrap a bit of teflon tape around it, then replace the o-ring where it was:
Put everything back together and enjoy!
N/A (I'll add ranges when the weather here is a bit nicer).
Edited by NetherMax1, 13 March 2016 - 03:51 PM.