When disassembling the Rotofury, the priming bar goes through the center of the cylinder and is thicker at both ends than the part that goes inside the cylinder. I am wondering if there is a way to somehow take apart this bar so that you can have just the cylinder without breaking it.
Rotofury Disassembly
Started by VNERF, Feb 28 2016 08:24 PM
2 replies to this topic
#2
beaker only
-
- Members
- 14 posts
Member
Posted 01 March 2016 - 02:28 AM
Not without breaking the solvent weld.Just about everything you need to do to a roto you can do without doing anything to the priming bar.
the difference between science and screwing around is writing things down.
#3
VNERF
-
- Members
- 13 posts
Member
Posted 01 March 2016 - 07:06 AM
That would be as simple as dipping it into boiling water for a few seconds at a time, right? And I assume the solvent welded piece is the piece that is often in the cylinder where the white and orange plastic meet? And the key word is just about, I am attempting to make a new cylinder, but I would need some way of getting the new cylinder on the priming bar.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users
