3 replies to this topic

[DKE15240]

This topic might be a little redundant but I need good but not expensive motors that can fit into a stryfe with no shell cutting. All the motors seem to be out of stock and when i search a motor that is still in stock I usually get a comment that its bad. So can someone send me a in stock link to good motors.


Also, I have 4 ultra fires, so if I could use them would be nice, but I am willing to buy other battery's.

[TheNerfZilla]

I would look into the Make Test Battle Rhino 130 motors. They were designed to be identical to the older falcon motors. I have not used upgraded motors, but these are what I am planning on using when I do. Don't just take my word for it, do a little more research first, but I hope I was able to point you in the right direction.

Link: http://www.containme...t-category/mtb/

[DKE15240]

I would look into the Make Test Battle Rhino 130 motors. They were designed to be identical to the older falcon motors. I have not used upgraded motors, but these are what I am planning on using when I do. Don't just take my word for it, do a little more research first, but I hope I was able to point you in the right direction.

Link: http://www.containme...t-category/mtb/

Do you think I have to use the 14 AWG wire they recommended or can i just use 18 awg?

[jwasko]

Thisis a video by the people who are selling the Rhino motors to distributors like Containment Crew. In it, he recommends 18AWG, silicone-insulated, stranded wire and uses Falcon motors...which, as I understand it, have the same specs as the Rhinos.

Also, here is a link to a pre-wired kit using Falcons and 18AWG wire.

So I think 18 is good enough, but 16 or 14 would be better.