I got an AT3K and want to mod it, but i dont really want to get any of those fancy barrels like ive seen on nerf sites. Any suggestions?
2 replies to this topic
#2
cxwq
-
- Founders
- 3,634 posts
Member
Posted 27 July 2004 - 01:11 AM
I guess you could get a Sharpie and write your name on it.
<meta name="cxwq" content="mostly water">
#3
Jangadance
-
- Members
- 676 posts
Member
Posted 27 July 2004 - 02:19 AM
Or if you wanna be elite, print your name and slide it into the emptied goo chamber.
Psyche, plug the pump, and buy some brass. $2 per foot at the hardware store, it's not too tough of "fancy". You don't need the clear PETG anyways. If you insist on it, buy a section of 1/2" CPVC pipe at the hardware store for $2. Cut off the stock barrels with a hacksaw and use epoxy to attach some CPVC barrels to it. Heck, use some Roseart or Crayola markers as barrels. But you're just gonna see progressively weaker results as you cut corners here. Up to you. Good luck.
Psyche, plug the pump, and buy some brass. $2 per foot at the hardware store, it's not too tough of "fancy". You don't need the clear PETG anyways. If you insist on it, buy a section of 1/2" CPVC pipe at the hardware store for $2. Cut off the stock barrels with a hacksaw and use epoxy to attach some CPVC barrels to it. Heck, use some Roseart or Crayola markers as barrels. But you're just gonna see progressively weaker results as you cut corners here. Up to you. Good luck.
"The 'dance goes on..."
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users
