Posted 23 July 2004 - 05:47 PM
Okay, so my buds and I bust out the PCs. Everything goes fine and then one of these beasts starts to "skip." This foam-shooting-piece-of-plastic has only had the removable clip and air restrictor mods... no air bladder reductions or whatnot. So, whats wrong? I narrowed it down to the green "piston" being a bitch.... and that's where yall come in.... any help is appreciated!
Posted 23 July 2004 - 09:53 PM
Posted 23 July 2004 - 10:18 PM
The screws, particularly towards the front of the gun, must be tightened to a very close tolerance. The above-mentioned catches, plus the rails molded into the case that the clip slides on are very finicky about case tightness. Play around with loosening or tightening various screws around this area and see if you can improve the situation.
Frequently, after a PC has been opened up the forward end of the green piston won't be seated fully in the side rail it slides on. Similarly, the foam-faced bit of plastic between this piston and the clip will often not quite get back into the spot it's supposed to be in. Open the gun up and wiggle these pieces around to make sure they are in their correct positions.
If all else fails, your new PC is in the mail.
Posted 24 July 2004 - 12:20 PM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users