Firefly owner(s):
Could you measure the full diameter of the rotating barrel/drum?
Cycloneshot owner(s):
Could you measure the full diameter of the rotating barrel/drum?
Also, could you measure the height of the shell from the bottom rail just bellow the drum (nowhere near the handle/grip), to the top rail above the drum?
THANK YOU!
Looking for some measurements...
Firefly + Cycloneshot
Started by BlasterHacker, Apr 08 2015 09:13 AM
5 replies to this topic
#1
Posted 08 April 2015 - 09:13 AM
#2
Posted 08 April 2015 - 09:58 AM
I think I know what you're trying to do
I can get some cycloneshock measurements up latertoday tomorrow because I'm a lazy bum.
I can get some cycloneshock measurements up later
Edited by pop tart, 08 April 2015 - 09:27 PM.
#3
Posted 08 April 2015 - 10:49 AM
I don't think this will work very well, unless you replace the Firefly plunger with something larger.
[15:51] <+Noodle> titties
[15:51] <+Rhadamanthys> titties
[15:51] <+jakejagan> titties
[15:51] <+Lucian> boobs
[15:51] <+Gears> titties
[15:51] <@Draconis> Titties.
[15:52] <+Noodle> why is this so hard?
[15:51] <+Rhadamanthys> titties
[15:51] <+jakejagan> titties
[15:51] <+Lucian> boobs
[15:51] <+Gears> titties
[15:51] <@Draconis> Titties.
[15:52] <+Noodle> why is this so hard?
#4
Posted 08 April 2015 - 12:28 PM
I think he is doing it vice versa.I don't think this will work very well, unless you replace the Firefly plunger with something larger.
If you are doing what I think you are doing, remember to replace the rotating mech. Good Luck!
It's like a Hurricane ate a Tornado and shat out a Monsoon!!
#5
Posted 09 April 2015 - 10:04 AM
Measurements please? (My local shop is out of stock Cycloneshots - I checked this morning, and I can't find a thrift shop Firefly to save my life)
Please don't post just to bump your thread.
USER WAS WARNED FOR THIS POST
Please don't post just to bump your thread.
Edited by Langley, 09 April 2015 - 12:26 PM.
#6
Posted 09 April 2015 - 05:14 PM
The diameter of the cylinder is 72 mm.
I'm not quite sure what you're asking for the second one. Do you mean the height of the gap in the shell for the cylinder or from the bottom of that gap to the tac rail on the top of the blaster?
I'm not quite sure what you're asking for the second one. Do you mean the height of the gap in the shell for the cylinder or from the bottom of that gap to the tac rail on the top of the blaster?
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users