3 replies to this topic

[Jtest]

I figured I would post a quick write up for an accessory I have been using.

Find a large rifle ammo case, I got this one at Academy for 2.99.


I had to cut off a loop normally used to allow a lock on the case.


Drill Small holes to fit the screws you have handy.


Drill larger holes so the head of your screw fits through.


I added a small layer of craft foam to make the darts fit snugly.


Paint as needed to match your blaster.


Use the case as a guide and drill two small holes in the shell, again sized to whatever screws you have on hand.


Mount to your blaster. Cheap and easy 20 dart "quiver".

[mcknight2012]

I like it. Cheap, easy, and functional. Good work.

[SolarFusion]

Nice find. Nothing fancy but very functional. One question though, if you run with it, do the darts shake out?

[Jtest]

Nice find. Nothing fancy but very functional. One question though, if you run with it, do the darts shake out?

The craft foam keeps them in there really snug. I have slung it up and down as hard as I can and they stay in place.

This is with new-newish darts. I would imagine older worn out darts may be easier to knock loose, but I always start every two day event with 400ish fresh darts.