CS- Tiff
Edited by CS- Tiff, 02 October 2014 - 04:17 PM.
Posted 02 October 2014 - 04:11 PM
Edited by CS- Tiff, 02 October 2014 - 04:17 PM.
Posted 02 October 2014 - 06:13 PM
Posted 02 October 2014 - 06:46 PM
Edited by CS- Tiff, 05 October 2014 - 05:20 PM.
Posted 02 October 2014 - 06:50 PM
Edited by CS- Tiff, 05 October 2014 - 05:21 PM.
Posted 02 October 2014 - 07:35 PM
Posted 03 October 2014 - 04:55 PM
Posted 03 October 2014 - 05:58 PM
Posted 03 October 2014 - 07:42 PM
Posted 03 October 2014 - 07:50 PM
Edited by CS- Tiff, 05 October 2014 - 05:22 PM.
Posted 03 October 2014 - 09:19 PM
Normal NiMH can only push at best 1500mA Normal AA can only do .5A or 500mA. If you use a microswitch rated to .5A only .5A can pass through it without generating heat over that can go through it but it will heat and can fail. Example of what can happen you have a stryfe you have blades in it low resistance wire and use a 25-50c battery pack then you use the switch that came with the stryfe the motors will attempt to draw up to 10A when a jam or dart hits the flywheels the only thing your gun has that cant handle that type of load is the switch. When the motors start pulling the amperage the switch passes it as best it can as it exceeds the switch it gets hotter and hotter until thermal failure occurs something burns or melts.Also, If i use a microswitch rated for .5 amps, will some nimH cells or a 2 amp lipo burn it out when i get some crazy stall motors?
and i dont get why lighter flywheels can be dangerous
Posted 07 October 2014 - 03:09 PM
Posted 07 October 2014 - 04:27 PM
The axle are a bit long you will need to cut them probably.What is better? Mabuchi FK180SH 3240's or these? http://www.ebay.ca/i...=item234020055e
0 members, 1 guests, 0 anonymous users