5 replies to this topic

[diedirk]

My problem with the rapid strike is that the magwell won't close can you tell me whats rong

Edited by diedirk, 24 August 2014 - 01:53 PM.

[jktrolldaddy]

see that white piece of plastic that is connected to the clip release? it looks as if that's not pushed down far enough.

[diedirk]

'jktrolldaddy', on 24 Aug 2014 - 9:47 PM, said:

see that white piece of plastic that is connected to the clip release? it looks as if that's not pushed down far enough.

no that's not the problem it is further up

[Fostis2]

Have you tried to realigning the Dart pushing Mech??? From the looks of the picture it appears to be at a slight angle.

[diedirk]

'Fostis2', on 25 Aug 2014 - 5:08 PM, said:

Have you tried to realigning the Dart pushing Mech??? From the looks of the picture it appears to be at a slight angle.

no that's no't the problem eighter but thanks for the suggestion

[HardBeat101]

If the problem is a misaligned part, you should try gently pressing on the shell until you find a place where there's no give. What's directly under that point is what's (most) out of place. I say most because it might not be the only thing, just what is hitting the shell.