Edited by diedirk, 24 August 2014 - 01:53 PM.
rapidstrike won't close
Started by diedirk, Aug 24 2014 01:47 PM
5 replies to this topic
#1
diedirk
-
- Members
- 5 posts
Member
Posted 24 August 2014 - 01:47 PM
My problem with the rapid strike is that the magwell won't close can you tell me whats rong
#2
jktrolldaddy
-
- Members
- 28 posts
Member
Posted 24 August 2014 - 04:47 PM
see that white piece of plastic that is connected to the clip release? it looks as if that's not pushed down far enough.
[size="7"][/size]KEEP CALM AND BAMF ON
#3
diedirk
-
- Members
- 5 posts
Member
Posted 25 August 2014 - 05:02 AM
see that white piece of plastic that is connected to the clip release? it looks as if that's not pushed down far enough.
no that's not the problem it is further up
#4
Fostis2
-
- Members
- 5 posts
Member
Posted 25 August 2014 - 12:08 PM
Have you tried to realigning the Dart pushing Mech??? From the looks of the picture it appears to be at a slight angle.
#5
diedirk
-
- Members
- 5 posts
Member
Posted 26 August 2014 - 08:41 AM
Have you tried to realigning the Dart pushing Mech??? From the looks of the picture it appears to be at a slight angle.
no that's no't the problem eighter but thanks for the suggestion
#6
HardBeat101
-
- Members
- 6 posts
Member
Posted 26 August 2014 - 06:27 PM
If the problem is a misaligned part, you should try gently pressing on the shell until you find a place where there's no give. What's directly under that point is what's (most) out of place. I say most because it might not be the only thing, just what is hitting the shell.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
