4 replies to this topic

[MacAttack]

I recently picked up a Buzz Bee Extreme Air Max 1 at Target for 3 dollars. I couldn't say no to that. To say the least it is not that expensive normally at 5 dollars. So I decide to do some mods to it and dub it "The Uber Air 1".

So that mods I have done includes:
Plugged pump and OPV
1/2" CPVC barrel (Eventually going to add RSCB clip to it)

Some other things I did to it includes:
Hot glue tank to internals
Replace pump handle
Add stock

The cardboard is to keep the barrel stable. I had some problems with it before.



The hotrod duct tape is only there until I get more E-tape


In the near future I plan on painting it and adding the RSCB clip.


The total length is just under 2 feet with the stock on it.
It is getting about 50-60' flat. Angled easily over 100' These are the ranges with Elite darts. I am going to test with stefans asap.

[TheNerfingFlamingo]

Is there an actual writeup?

[evilbunnyo]

I'm glad new members are posting content but this is lacking. You need to add more pictures if you are trying to do a mod guide. If you just wanted to share picture of your work do it in the Modifications and Paint job thread.

As for your "mod" I would remove all the hot glue you have and just super glue the coupler on the tank. Its much easier and cleaner. Check out mods for the buzz bee panther to see what I am talking about.

[MacAttack]

Is there an actual writeup?

There is not one as far as I know at this point. But I am working on one.

[Zorns Lemma]

There is not one as far as I know at this point. But I am working on one.

In that case you should have posted in here http://nerfhaven.com...?showtopic=5250 which is where people go to show off their modifications without having to bother creating a guide.