what you'll need for wye:
1 bag of 3 16mm conduit joint pieces
1 bag of 3 20mm conduit joint pieces
1 bag of 3 25mm conduit joint pieces
hotglue and hotglue gun or epoxy and epoxy putty
scissors
dremel
drill bit
small sanding bit
cutting disk bit
sand paper
for barrel and clip:
1 16mm conduit pipe
1 20mm conduit pipe
begin by cutting the 20mm joint like this:
then drill and sand out a hole in the 25mm joint piece like this:
glue the two pieces together like this:
cut the 16mm joint piece like this:
sand, put glue on/inside and insert pieces together like this:
make minor adjustments and the wye is done! I made a hopper using my wye:
Edited by Svensk review, 02 November 2013 - 05:19 PM.
