5 replies to this topic

[Havok]

I opened up my newly un-boxed stryfe to take out the dart sensor and the other locks. Since i do not have access to a soldering gun i had to put back in the other two locks. When i closed up the blaster it would not rev. I put the lock back in and it still won't rev. I have a clip with a few darts inserted. P.S. Sorry about the lack of pictures, I can't get any up at the moment because i am having troubles with transferring the photos to my computer. P.S.S. First post

[azrael]

Clearly, a wire has been accidentally disconnected, sir.

BTW, if you decide to mod it, don't use a soldering gun, use an iron. There's a guide on soldering on my blog, linked both in the Rayven mod guide and the technical pages part.

[xXhunter47Xx]

When you remove any locks on an electronic blaster you'll have to rewire too. There's no way to remove the locks without rewiring. You probably put the lock in wrong.

Edited by xXhunter47Xx, 28 August 2013 - 05:56 PM.

[DartSlinger]

When you remove any locks on an electronic blaster you'll have to rewire too. There's no way to remove the locks without rewiring.

Actually, you can. You can keep the sensor depressed by gluing something over the front. A thin piece of plastic such as a bread bag closer and super glue would work well.

[Naturalman7]

Actually, you can. You can keep the sensor depressed by gluing something over the front. A thin piece of plastic such as a bread bag closer and super glue would work well.

Removing a lock is not the same as permanently depressing it. But they have the same effect. If you remove a lock, you have to rewire.

[Havok]

When I say remove a lock, I mean the plastic pieces not the little silver boxes that are part of the wiring. Also I thought that I could remove the dart sensor with no need of rewiring.