5 replies to this topic

[hamoidar]

The topic Description pretty much sums it up, I just need to know in what ID brass pipe do stock darts have an air gun fit? I found this on mcmaster:http://www.mcmaster....8/3724/=jgojr9' class='bbc_url' title='External link' rel='nofollow external'>mcmaster Does anyone know if this will work? I realize that 1/2" PETG has an air gun fit, but I need to use brass for this particular blaster. Thanks in advance!

[Buffdaddy]

Usually, you will need 9/16", 0.014" thick brass tubing - stock darts tend to be a bit larger in diameter than half an inch.

[hamoidar]

Usually, you will need 9/16", 0.014" thick brass tubing - stock darts tend to be a bit larger in diameter than half an inch.

So 17/32(which is the next size up from 1/2") is still to small?

[BritNerfMogul]

17/32 for springers, 9/16 with tightening rings for airguns

[hamoidar]

17/32 for springers, 9/16 with tightening rings for airguns

Got it, Thanks so much!

[hamoidar]

Sorry for the double post, But I just want to make sure I get this right before spending 30 bucks on brass.
So this: http://www.mcmaster....8/3724/=jgpjl5' class='bbc_url' title='External link' rel='nofollow external'>mcmaster will have an air-gun fit with stock clip-system darts?

And the above brass will nest in this? http://www.mcmaster....8/3724/=jgpkbw' class='bbc_url' title='External link' rel='nofollow external'>mcmaster

Again, Mods, sorry for the double post , I should have thought about this before posting above post^