1/8” thick, polycarbonate.
NF trigger spring. (or equivalent)
Dremel (with sanding drum, cutting bit, and a plastic cutting disk)
Dremel circle cutter.
Hot glue gun
Micro-torch (or a candle)
First, unscrew the gun, and remove all internals.
Next, take the turret and dremel off each tab, as pictured:
Next, superglue the clutch ring on, as pictured:
Now, dremel the post, as pictured: (I will be saying “as pictured” quite a bit, so bear with me)
Next dremel the arch, as pictured:
And on the other side:
Dremel a bevel along the edge of the turret centering chuck:
This is to allow for easy turret insertion.
Super glue it into its slot:
Next, dremel off the front piece, yes, as pictured:
On both sides:
Edited by hamoidar, 24 March 2012 - 08:37 PM.