No replies to this topic

[venom213]

It has been frustrating for me in the past to try0 removing the priming handles from certain older blasters, namely the Sneakshot, Eagle Eye, and Sawtooth. Some people will tell you to pull and pry until they pop off, but in the process you often risk damaging the rest of the blaster or injuring yourself. I found a more elegant solution.

What you need:
-1/4" Hole Punch (similar metallic tubes could be substituted)
-Hammer
-Blaster that needs the priming handle removed.

We start off with the blaster. Look at that! All of the screws are out, but that meddling priming handle refuses to separate!



Put the punch over the priming rod on either end of the priming handle like so:



Hammer the punch down. I recommend holding onto the punch while you do this.



Finally, you should be able to separate the priming handle with ease. Notice how little damage that was done in the process!



Enjoy.

Edited by venom213, 17 March 2012 - 04:43 PM.