What you need:
-1/4" Hole Punch (similar metallic tubes could be substituted)
-Hammer
-Blaster that needs the priming handle removed.
We start off with the blaster. Look at that! All of the screws are out, but that meddling priming handle refuses to separate!
![Posted Image](http://i549.photobucket.com/albums/ii361/venomm213/IMG_1325.jpg)
Put the punch over the priming rod on either end of the priming handle like so:
![Posted Image](http://i549.photobucket.com/albums/ii361/venomm213/IMG_1328.jpg)
Hammer the punch down. I recommend holding onto the punch while you do this.
![Posted Image](http://i549.photobucket.com/albums/ii361/venomm213/IMG_1329.jpg)
Finally, you should be able to separate the priming handle with ease. Notice how little damage that was done in the process!
![Posted Image](http://i549.photobucket.com/albums/ii361/venomm213/IMG_1330.jpg)
Enjoy.
Edited by venom213, 17 March 2012 - 04:43 PM.