4 replies to this topic

[Tinkerer]

this mod makes the reactor shoot darts.

what you need:
1: x-acto knife
2: duct tape
3: 12" of 1/2" cpvc
4: NF cardboard target
5: superglue
6: 2" of 1/2"od 3/8"id pex tubing

1. disassemble the gun, and pry off the top section of orange at the end of the gun, and remove the black gasget.

2. using the x-acto knife, cut away the black air restrictors at the base of the pump thingy, and the black plastic lip around that, so the pex tubing can fit through the orange thing and into what used to hold the balls.

3. force the cpvc over the pex tubing about halfway (I had to do some serious shaving)

4. wrap the remaining pex in duct tape so there is a mostly airtight seal between it and the orange thing.

5. place the spring that used to advanse the balls, between the pump thing and the back of the pump tube as you reassemble the gun.

6. reassemble the gun

7. cut the NF target around the 50 pt. line, and cut a circle in the center, big enough to fit the cpvc through.

8. slip the piece of target over the cpvc and superglue it to the gasget.

now, with this mod, you should not ram the dart all the way down the barrel, 5-7" is good enough.

I got 70-80' flat with a forceful pull on it.

the spring in the pump tube makes the pump automatically push out once you fire, unless you're holding it barrel-up.

[Nazgul Lord]

Do you have any pics?

[Tinkerer]

what's there to see? it just looks like a normal reactor with a piece of cpvc in the ball magazine.

[Nazgul Lord]

Oh now i see. The pvc is near the end of the ball magazine and the nightfinder target helps seal the air in.

[Tinkerer]

no, the nf target is used to center the barrel, and the cpvc runs right down the ball tube to the opening at the base.