Materials:
1. CPVC
2. Reflex IX-1
3. Hacksaw/ pipecutters/ good martial arts skill
4. Hot glue
Instructions:
First, Take the plunger out of the blaster and remove the ar:
Take the plunger and cut it right where it gets wider:
Cut a piece of CPVC as long as the original barrel:
(the CPVC looks short in this pic, but it is just the angle)
Hot glue the CPVC to the piece with the O-ring. Make sure the glue is flush with the orange piece or it wont fit in the plunger tube:
(this is before I figured out it had to be flush)
Place the plunger into the plunger tube:
Hot glue the front barrel piece onto the CPVC. Trim the glue if necessary:
Put the plunger/barrel assembly back into the blaster:
Finished product looks stock:
Extra dart holder:
Take out the back of the plunger tube.
Wrap cpvc in e-tape until it can be shoved in very tightly:
With a dart:
If your CPVC is short enough, the cap can still be screwed on:
Ranges originally 20 feet flat.
New ranges: 35-40' flat
Questions? Comments? Flames?
Edited by Eraser475, 19 December 2011 - 07:31 PM.