Ok first off, the x-bow has a sm1k attached to it, as well with a laser pointer wired to the little button, conviniently located where my thumb can access it. I get about 70-80 flat with the x-bow barrel, the sm1k is untested. Although I'm guessing the sm1k ranges to be about 90-100, if not further. As for internal mods, it has a DT3 spring in there, and as you can see, rubber bands. The x-bow barrel itself has 2 inches of 17/32 brass in 10 inches of 9/16 brass, as well as the coupler combination like in Rawray's mod at NH. The trigger is still the same, with the keyring attached to the firing pin on the sm1k via duct tape and some k'nex I had laying around. It's a bit different than my previous x-bow AT2k mod, and it has a decent coat of paint on it.
The sm5k has an AT2k turret on it, and it's linked to the air chamber via a small piece of brass and alot of hot glue, the seal seems to be holding quite well. the barrels are slanted to compensate for the fact that I was too lazy to get the AT2k turret on exactly straight. Ah, and it's missing the 4th barrel because my ACE hardware ran out .
The nitefinder is just thrown in there for fun, and to fill in the space.
If you guys have any comments or suggestions, such as the barrel is too long on a gun or something, let me know, it's much appreciated. Also, feel free to ask any questions, or if I may have forgotten something. If anyone for some reason can't perform any of these by themselves, I can tell you how I did mine. (using text anyways)
~ompa
Edited by ompa, 12 May 2004 - 09:56 PM.