Unnamed Eab Creation
Posted 24 April 2004 - 09:35 PM
I finally decided to get off my lazy ass and finish one of my old projects. This gun has been made from scraps of many assorted things, but the valve is from a supersoaker (CPS 1000) and the pump is from a Larami 2000 (Sm5k lookalike). In case you were wondering the T-coupler on the back makes up most of the airtank. Range is very good, quite a distance past 100 feet, but the main thing I love is the velocity and accuracy. I have never seen another gun shoot with with the same velocity and accuracy as this one. ROF is also very good, thanks to the breach that I cut out of the shell. The only problem I have with this gun is that the pumping is a little awkward. Any input on where to relocate it is gratefully accepted. I couldn't stand the bright yellow pump handle, so that and the EaB trigger got painted black.
Posted 25 April 2004 - 12:41 AM
Posted 01 May 2004 - 12:23 AM
You can see in the third pic that I used a long, bendable brass sheet and formed it to the shell and pump, then wrapped the brass in extremely tight duct tape. That and the fact that the pump presses against a large section of the gun's shell make for an extremely sturdy pump. I think the gun also looks a lot better now, especially with the insulator padded foregrip. Thoughts?
Edited by Vassili, 01 May 2004 - 12:25 AM.
Posted 02 May 2004 - 02:29 PM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users