2 replies to this topic

[HappyHalloween]

Okay before reading this I suggest you go check out that Spectre Mod from around the 25th of November. Some one stated that the plunger tube as hollow and served only as a guide. So does this mean that you extend the guide tube and the shell, make the gun pul back, and slap a [k26] spring in there. Also cut off the front of the gun for longer cpvc barrels? Set up:

Cvpc barrels revolver Priming handle Extension of shell Pull back Rod

[k26]-----------------------------------------------[k26] Catch

Is this possible? If so there is a new 15 dollar Nerf blaster that is worth modding.
Could you get primary ranges off of this? And you would have 5 rotating shot. I think a hopper clip would be much to wide.

Answers? Feedback? Questions? Flames?

Edited by HappyHalloween, 28 December 2010 - 11:56 AM.

[HappyHalloween]

The set up got messed up.

Cvpc barrels revolver Priming handle Extension of shell Pull back Rod

[k26]-----------------------------------------------[k26] Catch

If it doesnt work now then what I meant was: First would be your CPVC barrels. They would go in to the revolving chamber. Then would be a section of shell followed by the priming handle. The priming handle would now be useless. Then onto the pull back rod there was a large extension. over the rod was a shell extension. On the rod would be a [k26] spring. And i assume the catch must go somewhere.

[Kid Flash]

Maybe you should try this. Then you can tell us if it works.