2 replies to this topic

[carlough]

I'm working on building a homemade titan tank, or something roughly the same size, and functioning in the same way.
Heres the hard part. I cant figure out how the original tank keeps the pressure from leaking out the bank where the metal rod goes through the back of the tank.

I'm not looking for someone to go and chop up a working titan tank. If someone already chopped one in half, or has a broken one that cant be fixed, I would much appreciate a picture of the valve.
The only titan thank that I have is already integrated, and in perfect condition. So I'd rather not cut it up.

And yes, I already searched the forums. I couldn't find anything.
If this topic shouldn't exist, then please delete it.

[Blue]

There is an O-ring that seals around the pin and presses at the back of the tank in it's special little housing, at least for all the supermaxx and air tech guns. You can see the little bump part that the pin comes out of. I think titans would use the same mechanism, I don't know for certain though.

Edited by Blue, 19 November 2010 - 09:49 PM.

[shardbearer]

You should look at the PVAT.