5 replies to this topic

[Floppyjack]

The new Stampede magazines are great, but can be a pain to carry. I thought of a way to have all three carried at once, and helps to reload.
I'm not sure if this has been done before, but here it is.

First, take your three magazines and place them a little more than one inch apart, and put a one inch block of wood in between them, as shown in the picture. (I used normal clips in this pic, but its the same as extended clips)

Place the blocks where the white and red rectangles are. You may want to double sided tape them in place, but this is optional.
Then wrap tape (I used electrical, because it looks best) around the clip starting from the ridge near the top and traveling about 3-4 inches down. You can also wrap tape between the clips to close everything in. When finished, it should look like this:

When put in the gun, it looks like this:

An easy, yet effective, mod. Questions or comments?

Edited by Floppyjack, 09 September 2010 - 06:49 PM.

[taerKitty]

This may add a bit more height to the 18-round clip, but it's narrower, and probably stronger:

[Floppyjack]

That's a good idea, and it actualey wouldn't add too much height. But the main problem is the upside down clips, as darts tend to fall out of them.

[Broderick]

That's pretty cool man. Don't the clips on the side get in the way of holding the gun, though (when the middle clip is in)?

[MavericK96]

I think a nice mod/official add-on would be a holder for a clip that slides onto a rail-system rail, such as the side rails on the Stampede. They're really not useful for anything else.

[Floppyjack]

Broderick,
It does, but not too much, and it's still possible to hold. I find it more effective to hold the gun with both hands at the pistol grip, becasue the center mass of the gun is there.

Maverick,
That would be a great attachment, the only problem would be finding reverse rails.