Materials:
½ Inch PVC
Super glue
Hot glue
Dremel
Angle or mitre box
Knife of some sort
½ Drill bit
Sand paper
First you want to bust out your angle or mitre box and mark and cut a piece of PVC at 45 degrees.
![Posted Image](http://i616.photobucket.com/albums/tt241/cheyner7/003-5.jpg)
Take your sand paper and wrap it around some ½ inch PVC. Sand your 45 degree cut on this until you get a nice snugish fit. You could also use the sanding drum on your Dremel if that’s how you roll.
![Posted Image](http://i616.photobucket.com/albums/tt241/cheyner7/004-2.jpg)
Now grab some more ½ inch PVC and your ½ drill bit. Use whatever method of drilling you prefer, I just use a spade bit with a ratcheting screwdriver. Drill 2 close to overlapping holes or one if you have some time.
Now use your knife/Dremel and connect the holes.
The next part is pretty much trial and error. Widen the hole so that no PVC shows when you hold your 45 piece up to it and look in the PVC.
![Posted Image](http://i616.photobucket.com/albums/tt241/cheyner7/006.jpg)
Time to trim your 2 piece’s down to size. You don’t want them to be too short, nor do you want them to be too long. Try to get them just long enough so that there is enough to hold the pipe going into the piece.
![Posted Image](http://i616.photobucket.com/albums/tt241/cheyner7/005.jpg)
![Posted Image](http://i616.photobucket.com/albums/tt241/cheyner7/002-6.jpg)
Now you need to make sure the ends of your wye can accept ½ CPVC.
This will be easiest with a dremel with a small sanding drum. Take your time and make sure to check your fit often.
![Posted Image](http://i616.photobucket.com/albums/tt241/cheyner7/006-1.jpg)
All 3 ends should more or less look like this.
Time to glue the 2 pieces together making sure it is lined up at the same time of course. I like to use a drop or 2 of super glue to hold it together before I smother it in hot glue.
![Posted Image](http://i616.photobucket.com/albums/tt241/cheyner7/009-1.jpg)
![Posted Image](http://i616.photobucket.com/albums/tt241/cheyner7/011.jpg)
Now all you have to do is follow this very timely posted thread and then strap it to something big and powerful.
![Posted Image](http://i616.photobucket.com/albums/tt241/cheyner7/014.jpg)
This design can easily be used to make wyes of all sizes, not just for ½ CPVC.
For my MEGAHAMP I used ¾ PVC, as it needed to accept ¾ CPVC and ½ PVC.