parts
2 nite finder o-rings
1 smaller o-ring
e-tape
buzz bee rapid fire rifle spring or stronger spring if you like
part of a recon inner barrel 3.in
raider trigger gaurd
#9 washer
long flat screw
hot glue gun and sticks
strong enough catche spring
tools
hacksaw
glue of choice
power drill with 5/8's drill bit
small Philips head screw driver
step 1 opening + plunger
unscrew the gun and take out the plunger and plunger. now get your 5/8's bit and drill and drill through all the way then unscrew the plunger head add the spring and put on the head but don't screw it in yet get your washer hot glue and long flat screw fill the circle on the head with hot glue and put the washer on so you can put the screw in perfectly strait and after put the 2nd nite finder o-ring on then wrap e-tape under the notches so the spring fits tight then cut the tape in half so the spring can't ride up. now put the smaller o-ring on the notches 3 o-rings better seal.
step 2 barrel
get the recon inner barrel then cut the half peace and stick then get 3 inches cut. glue it in so it can fit darts when you fire later you can push the dart to the end of the chamber that has the best results.
step 3 cosmetics
saw the light, ammo holders and half the trigger guard and get a raider and cut its trigger guard off and hot glue that on it fits better in holster
rang tests max i've gotten was 78.2 ft and min 49.5 ft with streamlines so i think there good ranges for a pistol.
Edited by natenerf25, 15 May 2010 - 08:45 PM.
