- PETG Barrel
- AR/restrictor peg removal
- Extra O-ring
- MAYBE a new spring
A) Use a dremel (I haven't got one), drill (unless I absolutely HAVE to), or
B) Make a new plunger tube
I hate to sound like a noob here, but the only mod I've done before is a stormfire O-ring mod. I also hate to make a new topic when it's not absolutely 100% needed, but this seems to fit that requirement.
So yeah, I've tried boiling water, and it almost melted the plastic. I tried acetone nail polish remover on my stormfire and it SERIOUSLY messed it up, and I've also tried an X-acto knife and the glue was just too thick, the seam too thin. I'm out of ideas, so anything (besides sawing the thing in half) is welcome. The reason I say I want to do this without a drill is because, like I said, I want to add a PETG barrel, which as far as I've seen, needs the AR 'container' to be opened up, which can't happen with the internals glued up, which brings me back to my original question.
Thanks for spending your time reading this post, and thanks in advance for any ideas you guys might have.