I was thinking about putting a Co2 connector on the magstrike to replace the pump. If anyone has done this before please reply to this post on how it worked out.
Magstrike Co2 Mod
Started by
jman263
, Mar 03 2010 09:04 PM
7 replies to this topic
#1
Posted 03 March 2010 - 09:04 PM
#2
Posted 03 March 2010 - 09:07 PM
Co2 gets too cold for plastics. You could try, but you'd probably end up with the internals of your guns fracturing.
#3
Posted 03 March 2010 - 09:15 PM
Then what other kinds of pressurized gases could I use.
#4
Posted 03 March 2010 - 09:18 PM
#5
Posted 03 March 2010 - 09:26 PM
I can make one for you.
You will have to use HPA ( high pressurized air ). Which can be used easily with paintball tanks. Or you could make your own. You will also have to have a regulator to regulate the pressure going through the system. Recommended PSI is 50-60.
You will have to use HPA ( high pressurized air ). Which can be used easily with paintball tanks. Or you could make your own. You will also have to have a regulator to regulate the pressure going through the system. Recommended PSI is 50-60.
Kid Flash "I mainly wanted the balls."
#7
Posted 04 March 2010 - 05:31 PM
Also keep in mind this will cost quite a bit of money, so you better be a very serious nerfer... or a rich one.
Like my page on Facebook! PM me, I do commissions!
#8
Posted 04 March 2010 - 06:40 PM
This guys been banned. All his posts are breaking rules.
New posts on my blog, check it out. - Click on the ad too, cause I get money per click. Give back to the Admin team for once!
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users