3 replies to this topic

[big j12040]

Hey guys i was just wondering if any of you knew how to reinforce a longshot trigger to be able to pull back atitan pin at 25 pumps. Mine has a piece of metal on the bottom and the trigger bends so if you can help please help me.

Edited by big j12040, 08 February 2010 - 11:08 PM.

[HOTH]

I use aluminum and brass sheeting for all my plastic reinforcements. I do not have any exact sizes, but go to your hardware store and choose either a brass or aluminum sheet that is not to thick, but not too thin either.

[Prince Valor]

If the brass or aluminum doesn't work, i reinforced mine with some epoxy putty and than sanded it down so it was flush with the sides of the trigger.

[SorrowX]

I make custom triggers (occasionally) from really thick music wire. You have to heat it up to bend it, otherwise it just breaks. When it is red hot (at the joint), it is ready to be bent.