Video at the end of the second post.
First, the gun:
^^That is just the shell.
Take out the plunger tube, and cut off the stock barrel flush with the tube:
Dremel out the Plunger tube until a PVC coupler fits in it snugly. I dremeled bit too much:
I had to wrap the coupler in electrical tape for it to fit:
Cut your coupler in half, to eliminate some deadspace:
The coupler, snug in the plunger tube:
Now, put a light layer of super glue on the connection. This is just to hold it in nicely, and we will do more for sealing the connection later.
Glued in:
While your super glue is drying, let's see what we can do with the plunger system. Take it out:
Here is the skirt head. Easy to pry off, but we do not need to.
Cut off the tip of a 3B arrow.
-
Dab some Hot Glue on your plunger head:
-
-
Now, our super glue should be dry enough to apply some more glues. I used my Hot glue, and slowly went around the connection, making it clean, but airtight as well.
DO NOT POST. PICTURE LIMIT.
Edited by HOTH, 14 January 2010 - 10:29 AM.