this is useful
Nice Airgun Trigger Design
it's not my idea but... it'll do the haven good
Started by OnyxZenith, Dec 17 2009 07:16 PM
3 replies to this topic
#1
OnyxZenith
-
- Members
- 191 posts
Member
Posted 17 December 2009 - 07:16 PM
this is useful
SoothSayer-
"Just adding some lube and twisting it back and forth for a while should make it easier"
Subscribe to my Music page and mods >> http://www.youtube.com/user/OnyxMP312
"Just adding some lube and twisting it back and forth for a while should make it easier"
Subscribe to my Music page and mods >> http://www.youtube.com/user/OnyxMP312
#2
Darth Freyr
-
- Members
- 102 posts
Member
Posted 17 December 2009 - 07:53 PM
Having built one of these, I have a few pointers. A good combination for those of us not in Europe is 1/8" brass tubing and a brass 3/16" barb to 1/8" MPT, at least those from my ACE. I found that the bulk fittings were better than the ones in the small plastic containers. I believe I also used a #4 flat head sheet metal screw. When I say flat head, I mean the actual screw head type, not the driver shape.
Please email me rather than sending a PM. I am DarthFreyr at gmail dot com
#3
MoonMaster
-
- Members
- 180 posts
Member
Posted 18 December 2009 - 04:45 PM
This valve is really similar to badwrench's air valve.
5. Protip: sarcasm is good for making someone else look like more of an idiot than they already do. However, if you are an idiot to start with, using sarcasm just makes you look like a COLOSSAL idiot.
#4
OnyxZenith
-
- Members
- 191 posts
Member
Posted 19 December 2009 - 01:47 AM
your right, as matter of fact I think it's just scaled down to like 1/5This valve is really similar to badwrench's air valve.
SoothSayer-
"Just adding some lube and twisting it back and forth for a while should make it easier"
Subscribe to my Music page and mods >> http://www.youtube.com/user/OnyxMP312
"Just adding some lube and twisting it back and forth for a while should make it easier"
Subscribe to my Music page and mods >> http://www.youtube.com/user/OnyxMP312
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
