ALSO if you have a Youtube account please subscribe, and check out my songs that I've published so far!
I GOT MY HANDS A NEW DREMEL, But I gotta say it sucks, after all it was only $19.98 at my local Walmart, 2 speeds, and it runs on a rechargable 4.8 volt battery pack and takes 3 hours to charge, and you only get so and so hours of rotary from it :/
ANYWHOOM off to the write-up!
I just gotta say, this makes a very decent assassination weapon, considering that it's so small, and that with this mod it will increase the capacity 3x and just a tad bit longer to load than having it singled.
1) MATERIALS:
-Dremel
--Sanding bit
--Cutting disk
-1/2 sch 80 PVC (thinkwalled)
-1/2 CPVC
-E-tape (I used duck tape, and it was a pretty sold fit
-Needle-nose Pliers / scissors
and last but not least but most important
-SSPB AS-1
---------------------THE PICS WILL BE VERTICAL BECAUSE I HAD TO USE MY IPOD TOUCH TO TAKE PICS OF THE PICS THAT WERE ALREADY ON MY IPOD--------------------------------------------------------------------------------
WRITE-UP:
BLASTER:
1) Take your SSPB and strip of it's shell, Chunk it away, you will no longer need it
2) Drilled out or pull out the stem/AR
3) Take your dremel and cut off the barrel up to this point, where it touches the edge to the airtank
4) Wrap E-tape/Duct Tape around the remaining barrel
CLIP:
1) take you sch 80 PVC pipe and cut it so it fits around 3 1.5in stefans
2) take your CPVC pipe and cut it about the size of 1 1.5in stefan
3) then take your sch 80 1/2 PVC pipe and take your dremel with a rough sanding bit and bore BOTH SIDES through the pipe. Up to the point where your sanding bit is covered by PVC
---(My dremel was sucky so it didn't get the bit all the way in, but it helped enough to fit the barrel and blaster together)---
4) take your pliers/scissors and then carve away at your 1.5in length CPVC
5) mount the PVC onto you blaster like shown
6) load 3 i.5in stefan darts
7) Cap off the clip with the CPVC barrel and jam it in tightly so its parallel to the PVC
8) pump and fire!
The ranges are around 50-60ft, I haven't measured my room to the wall at the end of the house, but I'm estimating 60 because so far all my blasters have smacked against the wall with every shot, besides my recon and maverick)
Now about how to reload, to reload simply just take the CPVC off and load 2 into the PVC and 1 primed in the CPVC barrel (I had a video of it until APPLE decided fail on me like their products always do
) then pump 8-10 times fire, then the 2nd dart will be primed 99% of the time if not you'll here a hollow sounding jiggle. Pump 8-10 times fire, then the 3rd dart will 99.99% of time will NOT be primed so to ready the dart swing the blaster in your hand like a dagger downward and you'll feel the dart swing into the CPVC barrel. Pump 8-10 Shoot.Questions? Comments? Flames?
Some pictures were provided from toxic's SSPB mod
Edited by OnyxZenith, 07 December 2009 - 10:02 PM.
