on a scale from one to ten on difficulty this is like a point five in my opinion.
i started off by taking the gun apart and sanding down that little piece under the plunger handle.
then you shave the inside screw holes down some so the tension spring will fit in place when the the screws are screwed on.
now place a screw and a lock nut on the other end of the two springs.
To reinforce the plunger you put a washer at the end of the plunger head.
finished gun should look like this:
about 50-60 ft
I don't know whats up with the sound in the video.
Its kinda crappy quality cause i filmed it on my cell phone because I lost my camera.
Edited by wohnson89, 14 November 2009 - 01:22 PM.