6 replies to this topic

[Noodleownz]

I have an RSCB clip on my BBB, and I'm sick of the copper always moving it down. Has anyone in the NIC made a stabilizer for the RSCB clip? E-tape looks way to messy! I was thinking about gluing the clip to my BBB, but that would put me at a disadvantage, if I wanted to take it off. If anyone has made a stabilizer please post here.

[berserker]

I cut a small notch the diameter of my PVC at the top lip of the BBB. My RSCB nestles in right there and towards the back I've zip-tied it down. Its easily removable and helps to prevent my RSCB from slipping off.

[flashflint]

I epoxy puttied a sanded out coupler to the side, works great.

[Noodleownz]

Sounds interesting. I might just put a very tiny strand of my extra strength hot glue on the cpvc cap thats on the end of the copper, and just put it on my BBB. That way it has just enough adhesive to stay but can be removed easily.

Edited by Noodleownz, 24 October 2009 - 09:49 AM.

[dubcwill]

3/4 in. copper end cap will go over your 1/2 in. cpvc coupler good enough to hold it.

[Hi Yah]

On my RSCB'd bbb I just twisted the clip so it's pressed up against the side of the gun.

[Samzilla]

You could use a pvc coupler/T or something like that glued to the gun which would fit the cpvc endcap on the rcsb.