3 replies to this topic

[Poseidon]

I've seen this done a few times before where someone has used one handle and trigger to fire two blasters at once. The closest example of what I'd like to do that I could find was dim3's Maverick(s) as shown in the far right of this picture...



What I was hoping to do was use two Stormfire's to do something very similar. However, I wasn't sure where exactly to begin and as I only have two spare StF's lying around, doing an overly large amount of experimenting wasn't an option. For starters, I wasn't sure if I would have to use one of the two StF's handles as my single handle or if a LS frontgun handle would do the trick. Essentially, if anyone who has done this before could give me any pointers, that would be great. I attempted to search, but found nothing explaining how it should be done. Any help would be greatly appreciated. This isn't meant to be theoretical or speculative; just asking a question. Thanks!

[Glint]

AssassinNF give's a good example of it here:
http://nerfhaven.com...6&hl=SwitchShot

Basically you have to attach the bodies to one handle and have two branches attached to the actual trigger that activate either catch/airpin/blast button.

[Stouty]

You could do similar to the gemini and link them with polycarb or even wire. You could cut off the existing handles and just use wire so push up the catch plates or even put a delay on one. With this the trigger would work like a doubleshot. It could take exsesive amounts of maching parts though. Make a writeup when you figure it out.

Good luck

EDIT Glint beat me to it.

Edited by Stouty, 03 October 2009 - 09:15 PM.

[Poseidon]

Thanks guys. That was pretty much what I needed.