Longshot Help
#1
Posted 27 August 2009 - 10:34 PM
The mods i have done are: ar removal, reinforced catch spring, added a nf spring and an industrial spring(weeker than a ace #49 spring), improved ph seal, and i lubricated the plunger tube.
I believe i should be getting better ranges.
Help would be greatly appreciated.
Thanks
P.S.
I won't be able to get pics for about couple of weeks from now.
#2
Posted 27 August 2009 - 10:47 PM
1. What did you "Improve the plungerhead seal" with?---double O-ring?...E-Tape?...Teflon tape? You may not have as good a seal as you think you do, or perhaps too good of one. A seal that is too tight will slow down the plunger motion and cause issues.
2. Your A/R removel----did you remove it completely, or just drill a hole through it? If it has not been completely removed your ranges will suffer.
3. What did you " lube the plunger assembly" with? The wrong type of lube could cause either break down of the O-ring, or "Sticktion"---which is a goofy word for the lube acting similar to an adhesive.
I sincerely hope this is of at least some benefit.----Rogue.
Rknight-- wow......N9---your dad is in trouble now!
#3
Posted 27 August 2009 - 11:34 PM
I used e-tape under my o-ring, and i used a silicone spray in a yellow can.
The fit on the o-ring is pretty good.
When i get my kink out what should my ranges most likely be at?
#4
Posted 27 August 2009 - 11:37 PM
Thanks Rogue
I used e-tape under my o-ring, and i used a silicone spray in a yellow can.
The fit on the o-ring is pretty good.
When i get my kink out what should my ranges most likely be at?
Hard to say---but with the springs you are using I would think 60'+ would be easily reached.---Rogue.
Rknight-- wow......N9---your dad is in trouble now!
#5
Posted 27 August 2009 - 11:58 PM
#6
Posted 28 August 2009 - 12:03 AM
1: You have the dart tooth in the gun.
2: You have covered the hole in the stock breech with etape or something.
That's all I can say.
#7
Posted 28 August 2009 - 11:59 AM
Make sure of two things.
1: You have the dart tooth in the gun.
2: You have covered the hole in the stock breech with etape or something.
That's all I can say.
I've both of those components in my gun. I covered the breech hole with hot glue and it's held out so far. Are there any other reasons that it would be performing below par?
#8
Posted 28 August 2009 - 02:58 PM
I have not covered that yet?
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users